1990 starcraft starflyer DIY suspension lift

now that we are up to a family of 5 tent camping was starting to become a bunch of work with all the blow up mattresses bedding excetra having a nice tent trailer like this was an easy decision since you can keep bedding and everything inside and it takes about 10 minutes to deploy the whole thing and have it ready to sleep and or eat ontop of that there are 3 beds, one king size bed, one queen sized bed and a double that the dining table folds down into. plenty of sleeping space for the bunch of us.

to start with i went to the local steel supply shop and bought some 2×4 steel tubing enough to go the length of the girder on the axle on each side and a piece to connect the two sides then i brought them to my work where i have access to a band saw which made quick easy accurate cuts. i then threw them in the back of the car and headed home, hooked up the camper and drug it over to my dad’s house to get the fabrication done.

first thing i did was to jack the whole thing up off the ground and rest it on jackstands, then remove the 4 bolts holding the torsion axle to the frame and i had to hammer the axle till the rust finally broke loose and let it fall free. then came the fabrication all i did was clamp the two short pieces to the torsion axle’s support girders and then slid the cross piece in to place, i actually had to take it to a shop and cut another 1/8″ off because it was just barely too long to fit. after trimming and a bunch of hammering and measuring to make sure everything was lined up correctly i finally got it all welded together. while i had it clamped and laying on the ground i went ahead and marked my 4 holes that i would have to drill for the mounting bolts.

Continue reading “1990 starcraft starflyer DIY suspension lift”